Call: 920.939.2819
Letter of Recommendation   Certificate of Recognition

Foundry Equipment > Aluminum Melting Furnaces > Micro Jet Melters (MJM) with Charging System > View Items  

Micro Jet Melters (MJM) with Charging System

Check up to five results to perform an action.

The Most Widely Recognized Name in Aluminum Stack Melting

High Efficiency Aluminum Melting

Ingot and scrap are charged into the stack section of the furnace. Charge materials are preheated by utilizing the flue gases directed through the stack. Heat recovery and energy savings are achieved by utilizing this method of preheating. The melt burner at the bottom of the stack completes the melting process. The molten aluminum flows into the bath section, where it is held at the desired metal temperature. The aluminum is then dipped, tapped or pumped out of the standard well section on the side of the holding bath section.

  • High energy efficiency – 1,000 BTU per pound
  • Reduced melt loss – less than 1%
  • High Quality Metal – Lower gas and inclusion levels
  • Temperature Control ± 18 °F
  • Capacities from 500 to 20,000 pounds per hour
  • State-of-the-art programmable controls with graphic display
  • Fully automated material handling, batching and charging systems
  • Complete system design and engineering services
When it comes to tower melt technology, no one offers more experience or know how. Modern Equipment has built and installed more tower furnaces in North America than any other manufacturer and provides an unmatched combination of research, design, and technical expertise to meet your individual needs.

Model MJM-800
Capacity2000 lb
Melt Rate 800 lb/hr
Dimension A14-6
Dimension B13-9
Dimension C15-1
Dimension D13-0
Temperature_Control± 10 ºF


  • 3 Sizes – 500, 800 & 1100 pounds per hour continuous production
  • Efficiency – Highest energy efficiency of any gas-fired furnace
  • High Metal Quality – Molten aluminum has lower gas & inclusion levels
  • Refractory Lined – No crucible to replace
  • Temperature Control – Low variations (± 10 °F)
  • Low Metal Loss – High metal quality = low dross formation
  • Easy to Clean – Convenient access doors make cleaning easy
  • Compact – See dimensions on back page

All Systems Include

  • Fully assembled & refractory lined
  • Electrical controls & interlocks
  • FM & IRI approved combustion system
  • Ease of maintenance & cleaning
  • System commissioning & training

Available Options

  • Equipment installation
  • Charging option
  • PLC & interface options
  • Multiple system configurations
  • Turn-key systems
Ask us about the “AL” Series Jet Melter for 1000# - 20,000# per hour production rates.